Wholesale Best Quick-Disconnect Couplings Suppliers – Hydraulic Fluid Power Connection Winner BSPT Connectors / Adapters – Winner Fluid

Product Introduction

Winner brand BSPT connectors at least has BSPT thread male or female connect end in the connector, BSPT is British Standard Pipe Taper thread, it is similar to NPT thread.

The BSPT thread has below characteristics:

1. The truncation of roots and crests of thread are flat

2. 55°thread angle

3. The angle between taper and center axis of pipe thread is 1°47’24”

4. Thread pitch measured per inch.

British Standard Pipe threads are similar in function to NPT threads, and the thread is similar, BSPT thread angle is 55°，NPT thread angle is 60°, the pitch and diameter are similar too, but they are not interchangeable. The thread dimensions compare list see below.

BSPT male threads seal against threads of fixed BSPT female, use of a thread sealant such as PTFE sealant tape is recommended for BSPT male to BSPT female connections.

BSPT adapter or BSPT connectors are popular, it is mostly used in Japan, China, almost not used in America. NPT adapter or NPT connectors are popular too, it is mostly used in America.

How to identify it is a BSPT thread and determine the thread size?

1. Visual inspection the thread and it is taper, or use a caliper measure the out diameter of external thread or the minor diameter of internal thread in different length position and found the diameter is different and meet 1:16 taper, or directly use a 1:16 cone gauge.

2. Use a caliper measure the diameter of base line position. Measure the thread diameter with an ID/OD caliper, external thread diameter is measured on the out diameter, and holding the caliper at a slight angle for a more accurate reading, for internal thread is measured on the internal diameter, and holding it perpendicular to the thread for a more accurate female reading.

3. Measure the threads per inch (TPI) or the pitch. As the measured diameter and use relational pitch gauge, try different thread gauges until determine the tightest fit, engage as many threads as possible, there are more thread engaged, the more accurate the reading. Hold the fitting/connector and thread pitch gauge up to the light, looking for gaps between the gauge and thread, this is easier to see on a external thread fitting/connector than a internal thread fitting/connector. Or directly measure the distance of two threads crest

The normal Winner plating of adapters/connectors are free of Cr6+, and the corrosion protection performance reached 360h no red rust, it exceeds normal standard.

Leave Your Message